NuTone NS5430SS Gebrauchs- und Pflegehandbuch Seite 4

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 3
NS54000 SERIES
Page 4
INSTALL THE WIRING INSTALL THE HOOD MOUNTING
BRACKET
1. GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
This appliance is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
2. Position the electrical outlet within the space covered by
the decorative flue and where it will not interfere with the
round duct. Make sure the outlet does not interfere with the
mounting bracket fastening area, ductwork, or where the
decorative flue touches the wall.
1. Construct wood wall framing that is flush with interior surface
of wall studs.
Make sure:
a) the framing is centered over installation location.
b) the height of the framing will allow the mounting bracket
to be secured to the framing within the dimensions
shown.
2. After wall surface is finished, carefully center and level the
hood mounting bracket and secure it to wall framing with (3)
#8 x 1-1/2” mounting screws. Tighten the screws completely.
Note: Do not use drywall anchors.
NOTES:
1. Minimum hood distance above cooktop must not be less than 24”.
A maximum of 30” above the cooktop is highly recommended for best capture of cooking impurities.
Distances over 30” above the cooktop are at the installer’s and user’s discretion - providing that ceiling height and flue length permit.
36¾” = bottom of hood 24” above cooktop
42¾” = bottom of hood 30” above cooktop
MOUNTING BRACKET LOCATION
(ABOVE 36” HIGH COOKTOP)
CEILING DUCT HOOD DISTANCE ABOVE 36” COOK TOP (SEE NOTE 1)
HEIGHT METHOD 24” 25” 26” 27” 28” 29” 30”
MOUNTING BRACKET LOCATION ABOVE 36” HIGH COOK TOP
8 FEET
DUCTED 36-3/4” 37-3/4”
38-3/4”
39-3/4”
40-3/4”
41-3/4”
42-3/4”
NONDUCTED 36-3/4” 37-3/4”
38-3/4”
39-3/4”
40-3/4”
41-3/4”
42-3/4”
9 FEET DUCTED OR
42-3/4”
NONDUCTED
C
L
9
4
1
2
FRAMING BEHIND
DRYWALL
WALL STUDS
1
9
16
R. 5-1/8”
7-1/2”
4”
20-3/4”
13
LOCATE
ELECTRICAL
OUTLET
WITHIN THESE
AREAS.
(Verify location
will not interfere
with duct,
mounting
brackets,
and flue.)
BACK OF HOOD
Seitenansicht 3
1 2 3 4 5 6 7 8 9 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare