Nutone OPENAIRE PFOB-52 Bedienungsanleitung PDF herunterladen

INSTALLATION INSTRUCTIONS

READ & SAVE THESE INSTRUCTIONS!

CAUTIONS

1. Before wiring the paddle fan, turn off the electric power supply

at the main fuse or circuit breaker box and leave

it off until the installation is complete.

2. Mount the outlet box so it will support a minimum of

45 pounds. The outlet box must be mounted flush to ceiling.

Do not use a plastic outlet box.

3. Do not install paddle fan with less than 7 feet clearance

between floor and lowest edge of fan blades.

4. If you are unfamiliar with electric wiring, acquire

the services of a qualified electrician.

5. Use proper cable and fittings. Be certain the fan is properly

grounded. Wiring must comply with national and local

electrical codes.

6. Electrical requirements: 120vAC, 60 Hz, single phase,

1 amp. – without optional lighting accessory.

7. Fan blades may be cleaned with a mild soap solution. Do not

use an abrasive cleaner or a strong chemical cleaner.

8. WARNING: To reduce the risk of fire or electrical shock,

do not use this fan with any solid-state speed control

device (NOTE: Refer to NuTone's catalog for appropriate

speed control switches.)

9. WARNING: To reduce the risk of personal injury,

do not bend the blade brackets when installing the

brackets, balancing the blades or cleaning the fan. Do not

insert foreign objects between rotating fan blades.

10. CAUTION: To reduce the risk of electric shock, connect only

to supply circuit provided with a ground fault circuit

interrupter.

11. CAUTION: To reduce the risk of electric shock, fire or

personal injury, a light kit must be marked suitable for use

with this fan and must be marked as suitable for outdoor use.

12. Do not operate reversing switch while fan blades are in

motion. Fan should be turned off and blades stopped before

reversing blade direction.

LOCATION

1. Minimum ceiling height: 8 feet. When fan is installed,

this allows a minimum of 7 feet between the floor and fan

blades.

2. The center of the fan must be located at least 32" from

any vertical surface.

3. Do not mount fan below, next to or between air ducts, beams

or any other obstruction which may interfere with the natural

air flow pattern created by the fan.

4. Fan can be mounted using down rod or closer to ceiling using

ceiling cup as close up adapter.

MOUNTING ON A SLOPED CEILING

1. Refer to Figure 1. A paddle fan equipped with a ball and

hanger bracket assembly can be safely mounted to a sloped

MINIMUM

MAXIMUM

25°

FIGURE 1

FIGURE 2

ALWAYS MOUNT HANGER

WITH OPENING TOWARD

TOP OF SLOPE

HEADER

OUTLET BOX

RUBBER

PADS

SUPPLEMENTAL

MOUNTING SCREWS

SOCKET

HANGER

ceiling where the maximum angle of the sloped ceiling does

not exceed 25°.

2. For any angled ceiling, use appropriate NuTone Extension

Stems to insure proper clearance between the blades and

ceiling. See NuTone catalog.

MOUNTING OUTLET BOX

Refer to Figure 2.

CAUTION: To reduce the risk of personal injury, install the

supplemental mounting means and use only the hardware

provided with the fan or use a listed outlet box marked as

acceptable for fan support. If the combined weight of the

ceiling fan and any light kit used with it exceeds 35 pounds,

the fan should be supported independently of the outlet

box. The weight of your fan is 20 lbs.

1. Fan mounts to a standard 4" metallic outlet box or a listed fan

support box. For damp location mounting, use outlet box listed

for “Damp Locations”. For outdoor mounting use outlet box

listed for wet locations.

“OpenAire”

MODEL: PFOB-52

1 2 3 4

Inhaltsverzeichnis

Seite 1 - “OpenAire”

INSTALLATION INSTRUCTIONSREAD & SAVE THESE INSTRUCTIONS!CAUTIONS1. Before wiring the paddle fan, turn off the electric power supplyat the main fus

Seite 2 - LIGHT KIT

2. When using a standard outlet box install a header betweenjoists and securely mount outlet box to header. Using twoscrews supplied with the outlet b

Seite 3 - IMPORTANT SAFEGUARDS

ATTACHING FAN BLADES1. Refer to Figure 5. Using three screws and washers fasten top and bottom blade bracket to blade as shown.2. Refer To Figure 6. U

Seite 4 - Two Year Limited Warranty

Product specifications subject to change without notice.4820 Red Bank Road, Cincinnati, Ohio 45227Printed in Taiwan, Rev. 3/02, Part No. 83012Two Year

Kommentare zu diesen Handbüchern

Keine Kommentare

Nutone OPENAIRE PFOB-52 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Faxe Nutone OPENAIRE PFOB-52 herunter. NuTone OPENAIRE PFOB-52 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Faxe Nutone OPENAIRE PFOB-52